Phone & tablet stands
A phone stand made for your exact phone and case
Generic phone stands either wobble or don't fit a thick case. FitPrint looks up your phone's published dimensions, asks whether you use a case, and designs a light, open-frame stand around it. The phone is placed into the design as a translucent ghost and checked automatically: it must fit the channel, rest on the foot and come out freely.
- Dimensions
- Looked up from manufacturer specs
- Check
- Phone fit, contact, insertion path, stability
- Weight
- Typically 20–40 g PLA
- Options
- Angle, cable slot, landscape/portrait
Design a phone standFirst part free · no credit card
Prompts
Design rules FitPrint follows
- Channel = device thickness + fit gap + 1 mm, front lip at least 8 mm.
- Back support at 60–70°, long enough to support roughly half the device height.
- Rear strut triangulates the back so the stand doesn't flex; the foot reaches under the centre of mass.
- Printed lying on its side — no supports, layer lines along the load.
Frequently asked questions
Do I need to measure my phone?
No — for common phones and tablets FitPrint finds the published dimensions on the web. Only the case thickness may be asked.
Can it make a car or bike phone mount?
Yes, but treat mounts for vehicles as prototypes and test them carefully; never rely on a printed part where failure is dangerous.
Related
Updated · Generated parts are a starting point — always test-fit before relying on a part.